Insulating glass production line consists of four sections, transfer section, washing section, inspection section and pressing section. It uses advanced technology to make high-quality and variety DGU automatically, such as double glass, triple glass, shaped glass and stepped glass. 

Transfer section

1. Low-e glass sensor

This sensor is installed before washing machine.It can automatically recognize Low-e glass,preventing the glass from dropping Low-e surface.

2. Conveyor roller

The transfer : The front and back transfer wheel are all moved, all actively transferred. It can  guarantee the big size glass and thick glass pass through smoothly.

Washing section

3. Materials

The whole washing and drying section adopt 304 stainless steel, including the plate and interior spare parts. 

The thickness plate can up to 4mm and the interior plate can be 8mm.The equipment performance is better and service life is much longer. 

4. Six Brushes

It has 6 brushes which are all soft brushes, can wash flat glass, temper glass and low-e glass. It has a diameter of less than 0.1mm bristles, never damage glass, especially for low-e glass .

5. Noise reduction device

The noise can be controlled below 90 decibels by using nylon gear and sponges.

6. Water heating system

 Adopts air heating system, use soft water to wash glass clearly.

7. Large frequency converter & Air knife ( Single or double air knife system )

1) There are one air knife system and one large frequency converter. The air knife can be divided into up & down two parts, both of them are frequency knife.The two parts will work at the same time when drying a large size glass (height>1.5m), while there is only down-parts drying for the small size glass (height<1.5m), saving much energy.

8. Automatically recognize glass thickness

1). There is a universal joint device, when the glass thickness was changed, the wind knife will move forward and backward to adjust the distance so that the relative distance between the wind knife and the glass is constant, so as to avoid damage to the glass due to the changes of the glass thickness.